LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Seats System (Frames- Service Information - 2 Of 2)) >> Seat Frames >> Rear Seats >> Lock Cylinder, Removing And Installing >> Rear Seat Backrest Lock Cylinder, Removing And Installing >> Removing

Rear Seat Backrest Lock Cylinder, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA72-10659Courtesy of AUDI OF AMERICA, LLC

-- Remove the trim and the locking mechanism. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .

-- Make sure the indicator is in the top position.

CAUTION:

Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

-- Release the four catches -arrows on the bottom- and use a key to press the locking cylinder -3- -2- out from the trim -1-.

NOTE:

Disregard the -top arrow-.

scientia non olet · About LEMON Manuals