Massage Mat Valve Block, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Cut the pneumatic lines to the compressor on the valve block according to the design of the old valve block.
-- Connect the pneumatic line. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING .
-- Connect the pneumatic lines to the massage mat air cushions on the valve block and give them a push again and then a final tug to see whether the coupling is locked in correctly.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
- Observe all measures when installing the Multi-contour seat. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
Install in reverse order of removal.