Refrigerant Circuit Connections With Valve For Switches

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Switching pressures, removing and installing switches as well as switch arrangement and version. Refer to REFRIGERANT CIRCUIT [For engine(s) CTUA, CAED, CREH, CEUC, CTGE, CREC, CYNB, CPNB]

Different threads for switch on high pressure and low pressure sides.
Only valves and seals that are resistant to refrigerant R1234yf and refrigerant oil must be installed. Refer to the Parts Information.

Courtesy of AUDI OF AMERICA, LLC

A - Connection (soldered in)

B - Seal

C - Valve (with Seal)

NOTE:

To remove and install the valve insert -C- when the refrigerant circuit is discharged, use, for example, an adapter from the Refrigerant Sockets:T10364 (Tightening specification. Refer to QUICK-RELEASE COUPLING CONNECTIONS ON REFRIGERANT CIRCUIT ).

There are different versions of these valves and therefore there are different tightening specifications. Valve insert -C- with a VG5 (5.2 x 0.7 mm, tire valve) thread has a tightening specification of 0.4 Nm ± 0.1 Nm; a valve insert with a M6 x 0.75 mm thread has a tightening specification of 0.9 Nm ± 0.1 Nm, and a valve insert with a M8 x 1.0 mm thread has a tightening specification of 2.0 Nm ± 0.2 Nm.