Right Side Vent Motor -V300-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Note the general information. Refer to GENERAL INFORMATION FOR ADJUSTMENT MOTORS .
-- Place the right front seat as far towards the rear as possible.
-- Turn off the ignition.
-- Remove the right center vent motor. Refer to Center Vent Adjustment Motor -V111-, REMOVING AND INSTALLING, "Convenience" VERSION .
-- Mark the connector and the actuator.
-- Disconnect the connector -3-.
-- Remove the bolts -1 and 4-.
-- Remove the adjustment motor -2- from the shaft -5- for the control lever.
NOTE:
It is possible that the shaft will also come out when removing the adjustment motor.