Front Bumper Beam Assembly

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground cable from the battery.
Remove the front bumper face. < Ref. to FRONT BUMPER FACE , REMOVAL, Front Bumper. >
Remove the energy absorber foam from the bumper beam assembly.

Fig 1: Energy Absorber Foam
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts, and remove the bumper beam assembly from vehicle body.

Fig 2: Locating Bumper Beam Assembly Bolts
Courtesy of SUBARU OF AMERICA, INC.

NOTE: After all bolts are removed, raise the whole bumper beam a little to remove it from vehicle body.