Component Location Overview - Components Inside Rear Passenger Compartment, Left Side Of Passenger Compartment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Rear A/C Display Control Head -E265-
- Only in the "Comfort" version
- There are different versions. Refer to the Parts information.
- Removing and Installing. Refer to Rear A/C Display Control Head -E265-, REMOVING AND INSTALLING .
- No child safety system is currently available (introduction not yet finalized).
- If a child safety system is offered in the future and is active in the vehicle, the setting of the rear A/C system and the seat heating/ventilation cannot be changed. Refer to the Operating Instructions.
- General Information. Refer to Rear A/C Display Control Head -E265-, GENERAL INFORMATION .
Rear Vent with Position Sensor in Left Rear Upper Body Vent - G630- / Position Sensor in Right Rear Upper Body Vent -G631-
- Inside the center console
- In the "Convenience" version
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function an. Refer to the Appropriate Wiring Diagram.
- Removing and installing. Refer to CENTER CONSOLE .
  NOTE:
  After replacement of the rear vent, perform an adaptation for the Climatronic Control Module -J255- control head and the Rear A/C Display Control Head -E265- to the end stops on the potentiometer. Use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.
Rear Temperature Selection Potentiometer -G538-
- Versions for specific countries
- Only in the "Basic" version
- Is a shared component with the trim and cannot be replaced separately
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function an. Refer to the Appropriate Wiring Diagram.
- Removing and installing. Refer to CENTER CONSOLE .
Left Rear Heated Seat Regulating Switch -E128-
- Only in the "Basic" A/C system
- The switch is not On Board Diagnostics (OBD) capable. However, seat heating activation only occurs when the Vehicle Electrical System Control Module -J519- provides the corresponding release. Refer to the Appropriate Wiring Diagram and Vehicle Diagnostic Tester in the "Guided Fault Finding" function vehicle electrical system control module.
- For information about seat heating function. Refer to SEAT HEATING .
- Seat heating, servicing. Refer to OVERVIEW - SEAT HEATING ELEMENT .
Right Rear Heated Seat Regulating Switch -E129-
- Only in the "Basic" A/C system
- The switch is not OBD capable. However, seat heating activation only occurs when the Vehicle Electrical System Control Module -J519- provides the corresponding release. Refer to the Appropriate Wiring Diagram and Vehicle Diagnostic Tester in the "Guided Fault Finding" function vehicle electrical system control module.
- For information about seat heating function. Refer to SEAT HEATING .
- Seat heating, servicing. Refer to OVERVIEW - SEAT HEATING ELEMENT .
Rear Seat Bench
- Depending on the vehicle equipment level with seat heating, seat ventilation
- There are different versions. Refer to the Parts information.
- For information about seat heating function. Refer to SEAT HEATING .
- For information about seat ventilation. Refer to SEAT VENTILATION .
- Seat heating, servicing. Refer to OVERVIEW - SEAT HEATING ELEMENT .
- Seat ventilation, servicing. Refer to Front Seat, Mounting on Fixture for Seat Repair .
Left B-Pillar Vent
- Only in the "Convenience" A/C system
- Removing and installing. Refer to Passenger Side Instrument Panel Vent, Removing and Installing .
Left Rear Footwell Vent Temperature Sensor -G637-
- Only in the "Convenience" A/C system
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function an. Refer to the Appropriate Wiring Diagram.
- Removing and Installing. Refer to LEFT/RIGHT REAR FOOTWELL VENT TEMPERATURE SENSOR -G637- / -G638-, REMOVING AND INSTALLING .
Right Rear Upper Body Vent Temperature Sensor -G636-
- In the air guide channel for the rear vent
- Only in the "Convenience" A/C system
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function an. Refer to the Appropriate Wiring Diagram.
- Removing and Installing. Refer to LEFT/RIGHT REAR UPPER BODY VENT TEMPERATURE SENSOR -G635- / -G636-, REMOVING AND INSTALLING .
Left Rear Upper Body Vent Temperature Sensor -G635-
- In the air guide channel for the rear vent
- Only in the "Convenience" A/C system
- To check, use theVehicle Diagnostic Tester in the "Guided Fault Finding" function an. Refer to the Appropriate Wiring Diagram.
- Removing and Installing. Refer to LEFT/RIGHT REAR UPPER BODY VENT TEMPERATURE SENSOR -G635- / -G636-, REMOVING AND INSTALLING .