Overview - B-Pillar Trim Panel
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool :T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips
- Vent
- Equipment levels
- Removing and installing. Refer to B-PILLAR VENT, REMOVING AND INSTALLING .
- Connect electrical harness connector, first insert lower vent in the trim and press on it until it engages audibly
- Upper B-Pillar Trim Panel
- Removing and installing. Refer to UPPER B-PILLAR TRIM, REMOVING AND INSTALLING .
- Lower B-Pillar Trim Panel
- Removing and installing. Refer to LOWER B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Clip
- Quantity: 2
- Insert in the trim panel
- Remove the clips that are still in the mounting points on the body using the Omega Clip Tool :T40280 .
- Replace damaged or deformed clips
- Lower B-pillar trim panel
- Button frames
- Air Ionization System Button -E677-