Overview - Lock Carrier Trim Panel, AVANT
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2.5 Nm
- Quantity: 3
- Rear Lid End Trim Panel
- Removing and installing. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING, AVANT .
- Press on until it engages audibly
- Stretch the rear lid seal lip
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool :T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips