Instrument Panel, Removing And Installing: Removing
-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.
-- Move the front seats all the way back and tilt backrests 45°.
- Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Note The Allocation Of The Airbag To The Instrument Panel.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the Driver Side Airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Remove the Steering Wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the instrument panel vent on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove the instrument panel vent on the front passenger side. Refer to PASSENGER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove the center instrument panel vent. Refer to CENTER INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove the instrument cluster. Refer to INSTRUMENT CLUSTER FRAME, REMOVING AND INSTALLING .
-- Remove the instrument cluster. Refer to OVERVIEW - INSTRUMENT CLUSTER .
-- Remove the Front Information Display Control Head -J685-. Refer to INFOTAINMENT SYSTEM DISPLAY, REMOVING AND INSTALLING .
-- Remove the Climatronic Control Module -J255-. Refer to CLIMATRONIC CONTROL MODULE -J255-, REMOVING AND INSTALLING .
-- Remove the Information Electronics Control Module 1 -J794-. Refer to INFORMATION ELECTRONICS CONTROL MODULE 1 -J794-, REMOVING AND INSTALLING .
-- Remove the upper instrument panel cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .
-- Remove the instrument panel center speaker. Refer to CENTER SPEAKER, REMOVING AND INSTALLING .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Country-specific with knee airbag: remove the knee airbag bracket. Refer to KNEE AIRBAG BRACKET, REMOVING AND INSTALLING .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Disconnect the connectors for the front passenger airbag. Refer to FRONT PASSENGER AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Remove the Anti-Theft Immobilizer Reader Coil -D2-. Refer to ANTI-THEFT IMMOBILIZER READER COIL -D2-, REMOVING AND INSTALLING .
-- Vehicles with windshield projection head up display: remove the screws -1, 2 and 5- and the Windshield Projection Head Up Display Control Module -J898- loose with the instrument panel.
-- To do this, slightly lift the control module -3- out and disconnect the connector -4-.
-- Remove the bolts -1 through 4- for instrument panel on the driver side instrument panel crossmember.
-- Remove the bolts -1 through 4- for instrument panel on the front passenger side instrument panel crossmember.
-- Remove the instrument panel bolts -1- on the center of the instrument panel crossmember.
Two technicians are needed to remove the instrument panel.
-- Disengage the bottom of the instrument panel from the bracket -2- -arrows- at the same time.
-- Disconnect the connectors and free up the wiring harnesses.
-- Carefully pull the instrument panel back from the instrument panel crossmember.
-- Remove the instrument panel from the vehicle interior and lay it on a soft surface.