Instrument Panel CROSSMEMBER

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Instrument Panel Crossmember

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 20 Nm
- Quantity: 2
Threaded Pin
- 20 Nm
- Quantity: 2
Mounting Bracket
- Removing and installing. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .
Bracket
- For Windshield Projection Head Up Display Control Module -J898-
- Equipped on some models
Bolt
- 9 Nm
- Quantity: 4
Bolt
- 20 Nm
Bolt
- 20 Nm
- Quantity: 4
Bolt
- 3.6 Nm
Bolt
- 20 Nm
Crossmember
- For the instrument panel
- Removing and installing. Refer to INSTRUMENT PANEL CROSSMEMBER, REMOVING AND INSTALLING .
Bracket
- For glove compartment/knee airbag
- Equipped on some models
- Removing and installing. Refer to GLOVE COMPARTMENT BRACKET, REMOVING AND INSTALLING, KNEE AIRBAG .
Bolt
- 9 Nm
Bracket
- For A/C unit
- Removing and installing. Refer to A/C UNIT BRACKET, REMOVING AND INSTALLING .
Bolt
- 9 Nm
- Quantity: 2
Screws
- 3.6 Nm
Bolt
- 9 Nm
- Quantity: 2
Bracket
- For the glove compartment
- Removing and installing. Refer to GLOVE COMPARTMENT BRACKET, REMOVING AND INSTALLING .
Bolt
- 25 Nm
- Quantity: 3
Bolt
- 9 Nm
Bolt
- 3.6 Nm
Bracket
- For the instrument panel cover
- Removing and installing. Refer to INSTRUMENT PANEL COVER BRACKET, REMOVING AND INSTALLING .
Bolt
- 20 Nm
- Quantity: 2
Nut
- 20 Nm
- Quantity: 2
- Always replace if removed