LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Interior Trim System (Service Information)) >> Interior Trim >> Instrument Panel CROSSMEMBER >> Mounting Bracket, Removing And Installing >> Installing

Mounting Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert mounting bracket in the mount on the windshield frame and affix only loosely with bolts -1 and 3-.

Further installation is performed in reverse order of removal, While Noting The Following: 

NOTE:

The Mounting Bracket Can Be Correctly Positioned Only When The Crossmember Is Installed.

-- First tighten the steering column with the mounting bracket to the crossmember. Refer to OVERVIEW - STEERING COLUMN .

-- Then tighten bolts -1- and -3- for mounting bracket.

scientia non olet · About LEMON Manuals