LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Airbags And Restraint Systems (Service Information)) >> Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Front Three-Point Seat Belt, Removing And Installing >> Installing

Front Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

Install in reverse order of removal and note the following:

-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

NOTE:

Make sure the connectors are installed all the way and engage audibly.

-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount -2- -arrow- and tighten the bolt.

GWWA69-0430Courtesy of AUDI OF AMERICA, LLC
WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

CAUTION:

When working on vehicles with the ignition switched on or with ready mode activated, there is a risk of the engine starting unexpectedly and of gas poisoning in enclosed areas. Risk of body parts and/or clothing being pinched or pulled.

Perform the following before switching on the ignition: 

  • Move the selector lever into P.
  • Activate the parking brake.
  • Turn off the ignition.
  • Open the hood
  • Connect the charger, such as the :VAS 5095A  to the jump start point on the 12 V vehicle electrical system.
  • Switching on the ignition

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY .

Vehicles with Left and Right Front Seat Belt Tensioner Control Module -J854- / -J855- (PR number 7W4 and higher):

-- After replacing the front three-point seat belt the seat belt tensioner control module must be activated using the Vehicle Diagnostic Tester.

-- Select the following tree structures one after the other in "function/component selection" :

NOTE:

Refer to the Electronic Parts information (ETKA) for the code to be entered for the new part.

-- After installing the three-point seat belt on the front passenger side, check the child seat anchorage function (depending on the country) of the belt. Refer to SEAT BELT FOR CHILD SEAT, CHECKING CHILD SEAT RESTRAINT FUNCTION, MARKET-SPECIFIC, NOT FOR DRIVER SEAT BELT .

scientia non olet · About LEMON Manuals