Right Flange Shaft, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION .
-- Remove the right front wheel. Refer to WHEELS AND TIRES .
-- Remove the right drive axle cover -1- in the wheel housing. Refer to NOISE INSULATION .
-- Remove the bolts -arrows- and remove the right heat shield -1-.
-- Remove the bolts -arrows- and then remove the heat shield from the right drive axle.
-- Remove the right drive axle from the transmission flange shaft and move it back. Refer to DRIVE AXLE .
-- Place the :SMN372500 under the transmission.
-- Install the threaded eye from the :3419 into the threaded hole in the right flange shaft with 2 M10 nuts -1-.
-- Position the :VW771 with the :VW771/13 on the threaded eye and remove the flange shaft.