Left Drive Flange Ball Bearing, Removing And Installing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Plate :VW401
- Press Plate :VW402
- Press Piece - Multiple Use :VW412
- Press Piece - 42mm :VW516
-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Remove the locking ring -1- from the flange shaft.
-- Remove the ball bearing -A- from the flange shaft
-- Install the ball bearing -A- on the flange shaft all the way.
- Place the bracket -B- on the ball bearing beforehand.
- Installed position for bearing bracket: Lettering on the bearing bracket faces the flange.
-- Install the locking ring -1- in the flange shaft groove.