Engine Mount

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Mount Exploded View

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 6 Nm
Subframe Mount Sensors
- Right side: Subframe Mount Sensor 1 -G748-
- Left side: Subframe Mount Sensor 2 -G749-
- Removing and installing. Refer to SUBFRAME MOUNT SENSOR, REMOVING AND INSTALLING .
  -- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .
Engine Mount and Actuator for Subframe Mount
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
  -- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .
- Includes Subframe Mount Actuator 1 -N513- on the right side
- Includes Subframe Mount Actuator 2 -N514- on the left side
Bolt
- 20 Nm
Engine Mount Bracket
Bolt
- 40 Nm
Engine Support
Bolt
- 90 Nm + 90°
- Always replace
Subframe
Bolt
- 55 Nm

Subframe Mount Control Module -J931-

Courtesy of AUDI OF AMERICA, LLC

Bracket
Connector
Subframe Mount Control Module -J931-
- Removing and installing. Refer to Subframe Mount Control Module -J391-, REMOVING AND INSTALLING .
  -- Calibrate the electro-hydraulic engine mount after calibrating. Refer to ELECTRO-HYDRAULIC ENGINE MOUNT, CALIBRATING .