Engine, Securing On Engine And Transmission Holder

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine and Transmission Holder :VAS6095A with Engine/Transmission Holder - V8 Engine Bracket :VAS6095/1-13

-- Free up the wiring harness.

-- Remove the nut -3- and free up the hose clamp.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamps -arrows- to remove the coolant hose from the upper left coolant pipe -2-.

-- Unclip the upper left coolant pipe from the mount -1-.

-- Remove the bolts -arrows- and remove the left engine support.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness.

-- Remove the nut -2- and free up the ground wire.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the right engine support -1-.

-- Secure the starter on the engine.

-- Attach the engine using the :VAS6095/1-13 to the :VAS6095A and tighten to 55 Nm, as shown in the illustration.

Courtesy of AUDI OF AMERICA, LLC