Overview - Steering Gear, Steering Gear With Tie Rods
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Electromechanical Steering Gear with Tie Rods
- With Power Steering Control Module -J500-
- Removing and installing. Refer to STEERING GEAR, REMOVING AND INSTALLING .
- Servicing. Refer to OVERVIEW - STEERING GEAR .
- There are different versions. Refer to the parts information.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.
- Bolt
- 80 Nm +180° turn
- Always replace if removed
- Subframe
- Nut
- Pushed into the subframe
- Always replace if removed
- Steering Intermediate Shaft
- Bolt
- Tightening specification, refer to -item 1- Bolt.
- Wheel Bearing Housing
- Nut
- 100 Nm
- Always replace if removed