Steering Intermediate Shaft, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

The threaded hole for the bolt must always be cleaned (for example, using a thread tap).

-- Make sure the rubber grommet fits correctly on the sealing boot before installing the steering intermediate shaft.

Courtesy of AUDI OF AMERICA, LLC

The arrow -1- point up in the installed position.

-- Move the steering intermediate shaft into its installed position from inside the passenger compartment.

Courtesy of AUDI OF AMERICA, LLC

-- The steering shaft must be held over the sealing boot on the upper steel shaft when being transported as illustrated.

-- Hold the steering shaft with one hand under the sealing boot on the sealing plug and by the lower steel shaft with the second hand as illustrated.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger of causing damage to the steering shaft and the sealing boot.

Do not carry the steering shaft by the steering shaft.
Do not remove the sealing boot from the steering shaft.
Do not overbend the joints past the stop.

-- The mount the steering intermediate shaft -1- all the way onto the steering gear -2- and tighten the bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Pull on the steering intermediate shaft -1- to make sure it is secure when the bolt -arrow- is installed. Then tighten the bolt -arrow-.

Install in reverse order of removal.