Front Door Latch and Door Lock Actuator Assembly: Removal
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the front door glass to the top position.
- Disconnect the ground cable from battery.
- Remove the front door trim. < Ref. to FRONT DOOR , REMOVAL, Door Trim . >
- Remove the sealing cover. < Ref. to REMOVAL , Front Sealing Cover . >
- Remove the glass run rubber (A) partially.
- Remove the rear sash.
- Remove the rod from the outer handle rod clamp.
- Disconnect the harness connector of front door latch and door lock actuator assembly.
- Remove the screws, and remove the front door latch & door lock actuator assembly.