Fan Shroud, Removing And Installing, AUDI A6: Removing

-- Remove the charge air cooler. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and air guide -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the air guide -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front noise insulation. Refer to NOISE INSULATION .

-- Remove the left and right bolts -1- and remove the radiator console with the radiator from the lock carrier in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

Vehicles without Torque Support 

Courtesy of AUDI OF AMERICA, LLC

-- Push the retainer back in direction of -arrow-, press the release down and disconnect the coolant fan connectors -1 and 2-, if applicable.

Vehicles with Torque Support 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the coolant fan connectors -1 and 2- to do this, push the clamp to the rear -arrow- and push the release down.

-- Remove the bolt -3- from the mount.

Continuation for All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Place the :VAS6208  under engine.

-- Remove the drain plug -1- and drain the coolant.

-- Lift the clip -2- and disconnect the coolant hose from the radiator.

-- Open the clamp -arrow- and remove the connection from the radiator.

Courtesy of AUDI OF AMERICA, LLC

-- Release the left and right radiator retaining pins and remove by pulling upward -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Move the radiator slightly forward.

-- Push the left and right locking latches for the fan shroud at the same time in direction of -arrow- and lift the fan shroud upward from the radiator and remove from underneath.

Courtesy of AUDI OF AMERICA, LLC