Connection Diagram - Coolant Hose, AUDI S6/S7 Without Parking Heater
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator for the charged Air Coolant Circuit
- Radiator
- Check Valve
- Charge Air Cooler
- Engine Oil Cooler
- Coolant Shut-Off Valve
- Activated by the Cylinder Head Coolant Valve -N489-
- Engine Coolant Temperature Sensor -G62-
- Engine Temperature Control Sensor -G694-
- Generator
- Cylinder Head
- For cylinder bank 1 (right)
- Coolant Recirculation Pump -V50-
- Bleed Screw
- Heater Core for Heater
- Removing and installing. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .
- ATF Cooler
- Removing and installing. Refer to ATF COOLER, REMOVING AND INSTALLING .
- Turbocharger
- For cylinder bank 1 (right)
- Turbocharger
- For cylinder bank 2 (left)
- Engine Coolant Circulation Pump 2 -V178-
- Cylinder Head
- Cylinder bank 2 (left)
- Coolant Pump
- Cap
- Checking the pressure relief valve. Refer to PRESSURE RELIEF VALVE IN CAP, CHECKING .
- Coolant Reservoir
- Map Controlled Engine Cooling Thermostat -F265-
- Transmission Fluid Cooling Valve -N509-
- After-Run Coolant Pump -V51-
- For Radiator Coolant Circuit for ATF Cooling
- Charge Air Cooling Pump -V188-
- Engine Coolant Temperature Sensor on Radiator Outlet -G83-