Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace the seal and O-rings.

-- Install the O-ring -1-.

-- Insert the coolant pump input shaft -2- into the oil pump mount as far as the stop.

-- Push the coolant pump -1- into the brackets on the upper part of the oil pan.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To connect the drive flange onto hex head of drive axle, turn at the impeller -2- until the coolant pump can be inserted completely.

Installation is performed in reverse order of removal, while noting the following:

-- Install the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING, FRONT .

-- Install the front lower coolant pipe. Refer to LOWER FRONT COOLANT LINES, REMOVING AND INSTALLING .

-- Install the radiator, with the fan shroud. Refer to RADIATOR, REMOVING AND INSTALLING, AUDI RS6/RS7 .

-- Install the Map Controlled Engine Cooling Thermostat -F265-. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .

-- Connect the coolant hose to the coupling. Refer to Figure.