LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 937 (Engine Cooling System (Service Information - CEUC, CTGE)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Lower Rear Coolant Pipe, Removing And Installing >> Installing

Lower Rear Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the parts information.

-- Coat the new O-ring with coolant.

-- Install the wires. Refer to RELAY PANELS, FUSE PANELS AND E-BOXES , and refer to the appropriate WIRING DIAGRAM.

-- Install the plenum chamber bulkhead. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to FILLING .

scientia non olet · About LEMON Manuals