Coolant Pump Toothed Belt, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Required preliminary procedure descriptions. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1- from the Oil Pressure Switch, Level 3 -F447- -2-.
-- Remove the bolts -arrows- and remove the toothed belt guard.
-- To do so counterhold the crankshaft on the vibration damper with the :T40263 , :T40314 and the 24 mm socket.
TIP:
The Drive Wheel Bolt Has Left-Hand Thread.
-- Counterhold the vibration damper and remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns -arrow-. Use :VAG1410 and :T10360 .
-- Remove the toothed belt -2-.