Component Overview - Run-Flat Tire (Pax)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle.
NOTE:
Be careful not to scratch off the glued- on wheel trim on these rims.
The surface of the wheel trim is very sensitive.
The rim will have be replaced if the wheel trim is damaged.
The wheel trim cannot be replaced.
- PAX Tires
- Support Ring
- Wheel for PAX Tires
- Note assembly instructions. Refer to WHEEL, CHANGING AND MOUNTING
- Wheel Electronics
- Batteries must be completely replaced.
- Remaining battery life, temperature and pressure can be read via diagnosis with Vehicle Diagnostic Tester.
- Metal Valve Body
- Only install valve according to parts information
- Delivered complete
- Wheel BoltNOTE:
Make sure the correct wheel bolts are installed. Refer to the parts information.
- Note assembly instructions. Refer to WHEEL, CHANGING AND MOUNTING
- Anti-theft wheel bolts. Refer to Figure
- Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS
- Wheel Bolt Adapter
- Place on wheel bolt designed for it. Refer to Figure
- Cap
- Place on wheel bolt
- Wheel Bolt, Two-Part
- Note assembly instructions. Refer to WHEEL, CHANGING AND MOUNTING
- Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS
- Cap
- Wheel Bolt Cover Cap
- Adhesive Balancing Weights
- Maximum 60 grams per rim permitted
- Clean wheel where it will be adhered so it is free of dirt and grease
- Remove protective film
- Attach balance weights to intended surfaces