Tires, Mounting
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
- Make sure wheel rim is clean.
-- After using tire sealing liquid, wheel electronics must be replaced, since there is the possibility of incorrect measurements due to liquid deposits on pressure sensor.
-- Insert a new tire valve.
-- Remove the valve insert.
-- Inflate tire to approximately 3 to 4 bar (43.5 to 58 psi), tire bead must audibly slide over rim hump.
-- Install valve insert.
-- Correct inflation pressure to the specified pressure.
-- Balance wheel.