Wheel Electronics System (Tire Pressure Monitoring System), BERU
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1410:VAG1410 and Torque Wrench 1410 Insert - Accessory Kit:VAG1410/1
WARNING:
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
WARNING:
Damaged wheel electronics must be replaced.
-- Push the wheel electronics -1- into the bed.
-- Install on the valve from the back with a microencapsulated screw
NOTE:
Replace the microencapsulated screw.
Tighten the microencapsulated screw to 4 Nm on all models.
Tightening specification for all models: 4 Nm