Registration Certificate Part II (Vehicle Title)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Contains information that the bearer of the registration certificate is not declared the owner
Only contains the current and, if available, last vehicle owner, the actual number of previous owners is indicated numerically
Only contains a small portion of the technical vehicle data
Does not document temporary vehicle decommissioning In the future, the vehicle and body type listed under digit 1 in the old vehicle documentation will no longer exist. It is replaced in the new documents with EU-standardized vehicle classes with body type

The introduction of the new registration documents results in hardly any changes for the driver.

As with the old vehicle registration the registration certificate part I (vehicle registration) should be kept in the vehicle and presented to responsible persons upon request.

It is not necessary to install the wheel/tire combination specified in the registration certification Part I (vehicle registration). All combinations approved according to the vehicle general type approval or EU operating license/type approval can be used.

The permissibility of a wheel/tire combination that deviates from the vehicle general type approval or EU type approval must be verified with an entry in the registration certificate part I (vehicle registration), an installation certificate due to a parts certificate or a general type approval for the wheel/tire combination.