RADIAL AND LATERAL RUN-OUT ON WHEELS/TIRES, CHECKING WITH Tire Dial Gauge :VAG1435

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Checking Lateral Run-Out:

-- Preload tire dial gauge approximately 2 mm.

-- Position dial gauge on tire side wall as shown in illustration.

-- Slowly rotate the wheel.

-- Note the smallest and the largest dial readings.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If the difference is greater than 1.3 mm, the lateral run-out is too great.

In this case, lateral run-out can be reduced by matched mounting of the tire. Refer to MATCHING .

Peak values on the tire dial gauge due to small irregularities in the rubber may be disregarded.

Checking Radial Run-Out:

-- Preload tire dial gauge approximately 2 mm.

-- Position dial gauge on tire running surface as shown in illustration.

-- Slowly rotate the wheel.

-- Note the smallest and the largest dial readings.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If the difference is greater than 1 mm, the radial run-out is too great.

In this case, radial run-out can be reduced by matched mounting of the tire. Refer to MATCHING .