Bumper Cover Mount, Removing And Installing, Vehicles From My 2015: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the headlamp housing. Refer to HEADLAMP, REMOVING AND INSTALLING .
-- Right: Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CPNB] or AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CTGE, CEUC] , AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CREC, CREH] and AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B5, 0CK] [FOR ENGINE(S) CYNB] .
-- Disconnect and free up the connector -1-.
-- If equipped disconnect the connector for the NOx Sensor Control Module -J583-.
-- Remove the bolts -1, 3 and 4-.
-- Remove the mount -2-.