Overview - Battery Jump Start Terminal
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Cable Holder
- Quantity: 2
- Nut
- 40 Nm
- For the wiring harness bracket
- Nut
- Tightening specification. Refer to the Appropriate Wiring Diagram.
- Wiring Guide
- With bracket
- Battery Jump Start Terminal -U6-
- Positive terminal grip with wiring harness
- Removing and installing. Refer to Battery Jump Start Terminal -U6-, REMOVING AND INSTALLING .
- Mount
- For Battery Jump Start Terminal -U6-
- Removing and installing. Refer to Battery Jump Start Terminal -U6- MOUNT, REMOVING AND INSTALLING .
- Bolt
- 4 Nm
- Quantity: 2
- Cover
- For the wiring harness
- Terminal 30 Wire Junction -TV2-
- Overview. Refer to Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING .
- Remote Start Connection
- 9 Nm
- Negative terminal grip
- B+ Terminal
- To the starter
- Connector
- To the starter
- 30/B+ Terminal
- To the generator
- Ground Wire
- On the engine support
- Nut
- Tightening specification. Refer to the Appropriate Wiring Diagram.
- Connector
- To the generator
- Connectors
- On the radiator fans