Secondary Air Injection Pump Motor -V101-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
During Installation, All Cable Ties Must Be Installed At The Same Location.
-- Remove The Front Right Wheel Spoiler. Refer to SPOILER LIP, REMOVING AND INSTALLING, AUDI RS6 .
-- Vehicles with auxiliary heater: remove the clip -arrow- and pivot the auxiliary heater tail pipe -1- backward.
-- Remove the right air intake grille from the bottom of the bumper cover. Refer to FRONT BUMPER COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -4- from the Secondary Air Injection Pump Motor -V101-.
-- Press the release buttons and remove the secondary air hoses -1 and 2-.
-- Remove the nuts -3- and the secondary air pump.