Secondary Air Injection Pump Motor -V101-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front left wheel. Refer to WHEEL, CHANGING AND MOUNTING .

-- Remove the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the air filter -2- from the mount in direction of -arrow-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

Audi RS6/RS7

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use A Cloth To Catch Any Leaking Coolant.

-- Remove the nut -3- and free up the coolant hose.

-- Clamp off the coolant hose -1- with the :3094 .

-- Loosen the hose clamp -2- to clamp off the coolant hose with :3094 and remove.

Continuation For All Vehicles

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

-- Remove the connector -3- from the bracket and disconnect it.

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons and remove the secondary air hose -2-.

NOTE:

Ignore item -1-.

-- Press the release buttons -3- to remove the resonator with the air filter.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the nut -2- and then press the Secondary Air Injection Pump Motor -V101- and the mount slightly to the side.

-- Remove the nuts -arrows- and the secondary air pump.