Wheel Bearing Housing, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Slide the wheel bearing housing onto the drive axle splines.

-- Insert both of upper control arm joint pins -2- in the wheel bearing housing and insert the bolt -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adhesive residue on the ball joint and guide link stub threads.

-- Install the guide link on the wheel bearing housing and tighten.

-- Install the control arm. Refer to CONTROL ARM, REMOVING AND INSTALLING .

NOTE:

Push the upper control arms -2- down as far as possible while tightening the bolts!

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolting -1-.

-- Install the brake rotor and the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING .

-- Tighten the drive axle to wheel hub threaded connection. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

-- On vehicles with automatic head lamp range control, perform headlamp basic setting. Refer to HEADLAMP, ADJUSTING .

-- If the Level Control Sensor -- was removed and installed or if the linkage was loosened, the control position must be programmed again by starting the correct program on the Vehicle Diagnostic Tester in Guided Functions .

-- If the control position was reprogrammed on vehicles with lane assist, the Camera Control Module -J852- must be calibrated again. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .

-- Install the wheel. Refer to WHEELS AND TIRES .

-- To determine if an axle alignment is required, see Table. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .