Stabilizer Bar, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Before starting the procedure, measure the distance from the center of the wheel to the lower edge of the wheel housing. Refer to WHEEL BEARING IN CONTROL POSITION, LIFTING VEHICLES WITH AIR SUSPENSION or WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
-- Place the vehicle on a hoist. Refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .
-- Remove the noise insulation -1-. Refer to NOISE INSULATION .
-- Disconnect left and right threaded connectors -2-.
-- Remove the left and right nuts -1- and remove the clamps -3-.
-- Remove the stabilizer bar.