Overview - Drive Axle: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Clamp
- Always replace if removed
- There are different versions depending the type of drive axle
- Tensioning. Refer to CLAMP ON TRIPLE ROLLER JOINT AND OUTER JOINT, TENSIONING .
- CV Boot
- If the drive axle has a peened triple roller joint AAR 3300 i, then the triple roller joint has an adapter installed
- Protective joint boot must fit in groove and on joint contour.
- Clamp
- Always replace if removed
- There are different versions depending the type of drive axle
- Tensioning. Refer to CLAMP ON TRIPLE ROLLER JOINT AND OUTER JOINT, TENSIONING .
- Locking Ring
- Always replace if removed
- Insert before mounting in ring groove (not visible with joint installed)
- Before installing CV joint, align sealing ring in center with opening facing upward.
- Outer CV Joint
- Replace only as complete unit.
- For removing. Refer to CV JOINT, SERVICING
- Checking. Refer to OUTER CV JOINT, CHECKING .
- For installing. Refer to CV JOINT, SERVICING
- For greasing. Refer to OVERVIEW - DRIVE AXLE
- When installing the joint on the profile shaft, the splines on the profile shaft must be lightly coated with grease used in joint.
- Bolt
- 200 Nm +180° turn
- Always replace if removed
- Before installing, clean the threads in the CV joint with a tap.
- Follow the sequence when loosening and tightening the threaded connection between the drive axle and the wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
- Clamp
- Always replace if removed
- Tensioning. Refer to CLAMP ON TRIPLE ROLLER JOINT AND OUTER JOINT, TENSIONING .
- CV Boot for Outer CV Joint
- Check for tears and scuffing
- Clamp
- Always replace if removed
- Tensioning. Refer to CLAMP ON TRIPLE ROLLER JOINT AND OUTER JOINT, TENSIONING .
- Drive Axle
- Removing and installing. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Triple Roller Star
- Mark installation position before removing
- Disassembling and assembling. Refer to DRIVE AXLE, DISASSEMBLING AND ASSEMBLING
- When installing triple roller star on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
- Locking Ring
- Always replace if removed
- Insert in shaft groove
- Bolt
- Always replace if removed
- Allocation. Refer to the Parts information.
- Tightening specification -Item 22- OVERVIEW - WHEEL BEARING
- Joint
- Disassembling and assembling. Refer to DRIVE AXLE, DISASSEMBLING AND ASSEMBLING