LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Suspension System (Front - Service Information)) >> Front Suspension >> Drive Axle >> Drive Axle, Removing And Installing >> Removing >> To Protect the Thread, Screw the Nut on the Pin Several Turns

To Protect the Thread, Screw the Nut on the Pin Several Turns

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Press the guide link joint pin off the conical seat using the :T40042  .

-- Turn the wheel bearing housing as far toward the inside as possible.

-- Remove the drive axle.

NOTE:

Be careful not to damage the dust boot when removing the drive axle.

Ignore -arrow-.

scientia non olet · About LEMON Manuals