Allocate the Assembly/Removal Tool for Removing the Joint

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

GWWA40-10050

Courtesy of AUDI OF AMERICA, LLC

-- Determine dimension -A- as shown in illustration.

Dimension -A- approximately 76 mm = drive axle with triple roller joint AAR 3300 i, use :T40018

CAUTION:

Make sure that correct special tool allocation for each drive axle.

-- Guide in the :T40018 for the triple roller joint AAR 3300 i behind the joint.

GWWA40-0354

Courtesy of AUDI OF AMERICA, LLC

Guide pins -1- must contact joint.

-- Move the :T40018 up against the joint by turning knurled screws -2-.

NOTE:

Secure the joint without play in the :T40018 .

Tighten the screws -2- only by hand.

-- Install the :VW771 in the :T40018 .

GWWA40-0353

Courtesy of AUDI OF AMERICA, LLC

-- Pull joint out horizontally with impact tool.

Leave the joint in the :T40018 .

-- Mark installation position of the parts -1 and 2- with lines.

GWWA40-0356

Courtesy of AUDI OF AMERICA, LLC

If they are not marked and are not installed in their previously installed positions, noises may occur later during driving operation.

A water-proof felt pen is well-suited for marking.

1 - Drive Axle

2 - Triple Roller Star

-- Remove grease with lint-free cloth.

-- Remove the circlip.

GWWA40-0357

Courtesy of AUDI OF AMERICA, LLC

1 - Pliers (commercially available)