Overview - Radio, MMI Radio Plus, 8DP
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Information Electronics Control Module 1 -J794- in the instrument panel holds the CD player/SD card reader
- The Radio -R- is integrated in the Information Electronics Control Module 1 -J794-
- Front Information Display Control Head -J685-, display in center of the instrument panel
- Multimedia System Control Head -E380- in the center console, QW1
- External Audio Source Connection -R199- AUX IN jack, in the center console storage compartment
- Sound System: Standard, 9VD
Optional
- Digital Radio -R147- integrated in the Information Electronics Control Module 1 -J794-, only Europe/Rest of World and QV3
- Radio System, Satellite -R146- integrated in the Information Electronics Control Module 1 -J794-, only USA and QV3
- CD Changer -R41- in glove compartment, 7A2
- External Audio Source Connection -R199- in the center console storage compartment, UF7
- Sound System: BOSE, 8RY
- Digital Sound System Control Module -J525- in the luggage compartment on the left rear side
- Cell phone preparation, 9ZF
- Bluetooth Hands-Free Calling, 9ZX
- Voice recognition system, QH1
- Antenna -R11- /Radio Antenna 2 -R93- in the Rear Window
- Front Information Display Control Head -J685-, Display in Center of the Instrument Panel
- Multimedia System Control Head -E380- in the Center Console
- Information Electronics Control Module 1 -J794- Inside the Instrument Panel
- External Audio Source Connection -R199- in the Center Console Storage Compartment
- Data Bus On Board Diagnostic Interface -J533- under the Rear Bench Seat
- MOST Bus
- Digital Sound System Control Module -J525- in Luggage Compartment on Left Rear Side
- CD Changer -R41- in Glove Compartment
- Sound Systems
- Antenna Amplifier
Fault Finding is performed using the "Guided Fault Finding". Refer to Vehicle Diagnostic Tester.
Notes on MOST bus
The optical data bus "MOST bus" is used in addition to the CAN bus.
A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.
Replace the complete fiber-optic cable if possible.
The front surface of the connectors must not be contaminated.
If disconnecting the connectors: Attach the :VAS6223/9 .
When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink the fiber-optic cables.
Repairing fiber optic cables. Refer to FIBER-OPTIC CABLE .