LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 922 (Entertainment System & Communication System (Service Information - 1 Of 2)) >> Communication >> Infotainment System >> Infotainment System Display, Removing And Installing >> 8 Inch Display With Kinematics, Removing And Installing >> Notes

8 Inch Display With Kinematics, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

The Front Information Display Control Head -J685- (Display) is located in the center of the instrument panel.

NOTE:

Only when the display is to be disconnected from the kinematics does the Front Information Display Control Head -J685- have to be brought into the service position before removal. Refer to 8-INCH FRONT DISPLAY SERVICE POSITION .

If only the display with kinematics should be removed and installed, then the service position for the Front Information Display Control Head -J685- is not necessary.

-- If the Front Information Display Control Head -J685- was brought into the service position, the Vehicle Diagnostic Tester must remain connected.