8 Inch Display With Kinematics, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Install in reverse order of removal. Note the following:
-- Make sure that the wiring guide of the Front Information Display Control Head -J685- to the wiring harness and Information Electronics Control Module 1 -J794- is followed exactly -arrows-, otherwise the Front Information Display Control Head -J685- will not extend out.
-- First install the clip in the center -2-, then connect the display connector -1 and 3- and then install the rear clip -4- and finally connect the engine connector -5-.
-- Slide the Front Information Display Control Head -J685- into the instrument panel and tighten the screws -2- hand-tight.
After installing the center vents, align everything and tighten the screws.