Lane Change Assistance, Calibrating: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Unit:VAS6350A
Conditions
-- Under the following conditions the Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770- must be calibrated in the "Guided Fault Finding" or "Guided Functions" operating mode. Refer to Vehicle Diagnostic Tester.
- Lane Change Assistance Control Module -J769- or Lane Change Assistance Control Module 2 -J770- was replaced.
- The rear bumper cover was damaged by a parking block, for example.
- The rear bumper cover was removed and installed.
- "No or incorrect basic setting/adaptation" is stored in the DTC memory.