LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Transmission System (Controls & Housing - Service Information - 8-Speed Automatic - 0BK AWD)) >> 37 Controls, Housing >> Selector Mechanism >> Selector Mechanism, Removing And Installing >> Installing

Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

-- Install the selector mechanism function unit and tighten it from the top.

-- Install selector lever cable. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the driveshaft intermediate bearing. .

-- Install the front ashtray or storage compartment. Refer to CENTER CONSOLE .

-- Install the selector lever handle. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING, SIDE LOCKING BUTTON .

scientia non olet · About LEMON Manuals