Automatic Transmission Fluid (ATF), Draining And Filling: Draining

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The transmission should be at operating temperature to properly drain the ATF. Do not start the engine when there is either very little or no ATF in the transmission.

The engine is off.
Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
Transmission is in "P".
The parking brake button should be activated to close the electro-mechanical parking brake.

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION .

Courtesy of AUDI OF AMERICA, LLC

-- Place the :SMN372500 under the transmission.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the ATF drain plug -arrow B- and drain the ATF.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Follow the disposal requirements.

Replace the ATF drain plug and seal.

Replace the plug for the ATF check and fill hole.

-- Tighten the new drain plug -arrow B-.

CAUTION:

Danger of causing damage to the transmission.

Only use the Automatic Transmission Fluid (ATF) available as a replacement part for the automatic transmission 0BL.
Allocation: Refer to parts information.
Using other fluids can cause malfunctions or transmission failure.
The ATF filler adapter must be clean. Do not mix the ATF with any other ATF types.
Engine must not be started if only a small amount or no ATF is in the transmission after repair work or after significant ATF loss.