LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Transmission System (Controls & Housing - Service Information - 8-Speed Automatic - 0BK AWD)) >> 37 Controls, Housing >> Automatic Transmission Fluid (ATF) Circuit >> Automatic Transmission Fluid (ATF) Pipes, Removing And Installing >> Installing

Automatic Transmission Fluid (ATF) Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. At the same time pay attention to the following:

CAUTION:

Danger of causing damage to the transmission.

  • Remove all the plugs on the ATF lines and on the transmission that were installed during removal.
  • The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.

-- Install the ATF lines all the way and then the clips -1 and 4-.

GWWA37-10988Courtesy of AUDI OF AMERICA, LLC

-- Re-tighten the bolts -arrows- to the tightening specification.

GWWA37-11281Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals