Tightening Specifications: Installing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. At the same time pay attention to the following:
-- Lightly coat the ATF supports with ATF.
-- Insert the ATF line -1- all the way on the ATF supports until the catches are released.
-- In this position push down the quick-release coupling clip.
-- Loosen all three bolts -arrows-, but do not remove.
CAUTION:
The ATF cooler can be damaged my ATF lines installed under stress.
- By loosening the bolts tension is created in the ATF lines.
-- Re-tighten the bolts -arrows- to the tightening specification.
-- Check the ATF level. Refer to AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL, CHECKING .