Automatic Transmission Fluid (ATF) Cooler, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. At the same time pay attention to the following:
-- Install the ATF lines all the way and then the clips -1 and 4-.
-- Loosen all three bolts from the ATF lines -arrows-, but do not remove.
CAUTION:
The ATF cooler can be damaged my ATF lines installed under stress.
- By loosening the bolts tension is created in the ATF lines.
-- Re-tighten the bolts -arrows- to the tightening specification.