Overview - Operating Cables
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm
- Quantity: 2
- Cable Mounting Bracket
- Selector Lever Cable
- Do not bend
- Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease :G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Adjusting. Refer to SELECTOR LEVER CABLE, ADJUSTING .
- Bring into installed position. Refer to SELECTOR LEVER CABLE, BRINGING INTO BASIC SETTING .
- Clip
- For selector lever cable
- Gearshift Lever
- Bolt
- 13 Nm
- For selector lever cable adjustment
- On the gearshift mechanism
- O-Ring
- Replace after removing
- Clip
- For selector lever cable
- Replace after removing