Tunnel CROSSMEMBER, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .
-- Place the :T10337 on the :VAS6931 and set it on the bottom of the transmission, as shown in the image.
-- Raise the transmission slightly.
WARNING:
There is the risk of an accident.
- The :VAS6931 may only be used during assembly and must not sit unsupervised under the vehicle.
-- Remove the bolts from the front muffler -arrows-.
-- Remove the bolts from the tunnel crossmember -arrows-.
-- Remove the nuts -arrows- and the tunnel crossmember.