ATF, Draining And Filling: Filling: Notes

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Danger of causing damage to the transmission.

Only use the listed replacement ATF for the S tronic transmission 0CK.
Using other fluids can cause malfunctions or transmission failure.
For the correct allocation. Refer to the parts information.
The :VAS6617 must be clean and ATF must not be mixed with another fluid! Rinse the hand pump with ATF if necessary.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the inspection and fill hole sealing plug -arrow-.

Courtesy of AUDI OF AMERICA, LLC

Vehicles with Aluminum Transmission Fluid Pan:

Courtesy of AUDI OF AMERICA, LLC

-- Connect the :VAS6617 with :VAS6617/1 and :VAS6617/2 to the ATF check and fill hole.

Vehicles with Plastic Transmission Fluid Pan:

Courtesy of AUDI OF AMERICA, LLC

-- Guide the :VAS6617 with :VAS6617/1 and :VAS6617/12 in the hole.

All Vehicles

CAUTION:

Risk of damaging the transmission by mixing ATF and transmission fluid (MTF) through the same bleeder.

The ATF filling quantity of 3.5 liters (3.7 quarts) must not be exceeded.

-- Fill the transmission with 3.5 liters (3.7 quarts) of ATF using the hand pump.

-- Connect the Vehicle Diagnostic Tester with the vehicle and start the Diagnostic mode.

Select Vehicle Test
02-Transmission Electronics, Functions
02-ATF Level → 02-Fill ATF

-- Follow the instructions in the display.

-- Tighten the inspection and fill hole sealing plug -arrow-.

Courtesy of AUDI OF AMERICA, LLC